Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Yorkshire, VA

Garage Door Roller Replacement in Yorkshire, VA

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Typical cost $150-$350.

Need garage door roller replacement in Yorkshire, VA? We diagnose the problem, give you a price before any work starts, and finish most jobs in a single visit. Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

When to call for garage door roller replacement

  • Grinding, squealing or rumbling as the door moves
  • The door shakes or jerks in the track
  • Cracked, chipped or wobbly rollers
  • Rollers that no longer spin freely

What usually causes it

  • Worn-out bearings in steel rollers
  • Cracked builder-grade plastic rollers
  • Rust or dust packed into the bearings

Safe checks before you call

  • Watch the rollers while the door moves. They should roll, not slide.
  • Look for cracked plastic wheels or wobbling stems.
  • Leave the bottom rollers to a technician. They sit in brackets that hold cable tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Inspect every roller, hinge and track section
  2. Replace rollers one hinge at a time, with sealed nylon rollers for a quieter door
  3. Replace the bottom rollers safely with tension controlled
  4. Lubricate hinges and bearings
  5. Test for smooth, quiet travel

How much does garage door roller replacement cost?

$150-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Local garage door roller replacement for Yorkshire, VA

With large seasonal temperature swings in Virginia, track brackets and hinge screws work loose over time, and a loose track is the most common reason a door rubs, binds or comes off its rollers.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

Our garage door roller replacement service covers Yorkshire (ZIP codes 20111, 20113 and 20121) and nearby towns including Manassas Park (1.3 mi), Loch Lomond (1.7 mi), Sudley (2.7 mi) and West Gate (2.8 mi). Call (833) 435-8883 to book a visit in Yorkshire.

Garage Door Roller Replacement: frequently asked questions

How much does garage door roller replacement cost in Yorkshire, VA?

Garage Door Roller Replacement typically costs $150-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do garage door roller replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is garage door roller replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Virginia or Yorkshire requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Yorkshire, VA

Marantec Remote & Keypad Programming

Marantec is a German manufacturer of residential and commercial door openers.

Typical $50-$150

Sommer Garage Door Sensor Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $100-$250

Chamberlain Remote & Keypad Programming

Chamberlain is the retail line of The Chamberlain Group, sold at home centers. It uses the same Security+ 2.0 remote technology and myQ app as LiftMaster, so many accessories work with both brands.

Typical $50-$150

Skylink Remote & Keypad Programming

Skylink makes openers and a wide range of universal replacement remotes and keypads.

Typical $50-$150

Windsor Door Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Hörmann Garage Door Installation

Hörmann is a German manufacturer of residential and commercial doors and openers with North American operations.

Typical $1,200-$4,500

Craftsman Garage Door Sensor Repair

Older Craftsman openers with model numbers starting with 139 were built by Chamberlain, so their remotes and parts often match Chamberlain and LiftMaster models from the same era.

Typical $100-$250

CHI Overhead Doors Garage Door Track Repair

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $150-$400

Raynor Torsion Spring Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $200-$450

Haas Door Garage Door Track Repair

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$400

Stanley Remote & Keypad Programming

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $50-$150

Moore-O-Matic Opener Gear & Sprocket Replacement

Moore-O-Matic openers are no longer made. We can often keep one running with available parts, or recommend a modern replacement.

Typical $125-$275

Garage door stuck, noisy or broken?

Talk to a garage door technician in Yorkshire, VA now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote